Zigbee Wireless application-developing module

AT command Support RS232 RS485 or USB Suitable for Commands Communication and Remote control. Two way communication

T-28 U-Bee zigbee Wirelee Module

Big differences to compare with all of the IEEE 802.15.4 based products in the market are that US-T28 is not a simple RF module but with embedded solution which allows users to implement various kinds of applications. No need to bother the sophisticated development environment and lots of RD chores, simple settings via common PC will be sufficient.

 

Such high level of integration helps to reduce the overall system cost and simplifies the development efforts during the process. In particular, the standard device can also incorporate a wide range of digital and analog peripherals for further developments.

Where there’s situations need to extend the wireless control coverage, a power amplifier (PA) module can be easily adhered to the US-T28. No additional efforts need to be done. US-T28-PA, a radio frequency (RF) front end module integrating a highly efficient and linear one-stage power amplifier (PA), RF switches, a low noise amplifier (LNA) and a band-pass filter (BPF). Using this integrated RF front end module, not only the required board space can be reduced, but also the external components.

1.2 Specifications

 

1. Small form factor, 20 x 20 mm2 PCBA package

2. Utilizes globally available 2.4GHz ISM band.

3. AT commands provided for control and configure.

4. 65535 unique node addresses, IDs allow multiple large networks to coexist.

5. Transmit Power Output, 0 dBm

6. Complete IEEE 802.15.4 specification compliance 7. Typical Receiver Sensitivity -95dBm

8. Typical throughput data rate 250,000bps

9. Non-Obstructed signal range to 500 meters @ 15 dBm

10. Multiple Low Power Operating modes.

 

US-T28-PA

2. TX mode

13dBm P1dB output power (UP2206: 24.5dBm)

9 dB linear gain at Pin=0dBm (UP2206: 15 dBm)

30% efficiency at 10dBm output power

23mA current consumption at 12dBm output power (UP2206: 130mA)

3. RX mode

-8dBm input 1dB compression (UA2725: -1.5dBm)

Flat 15dB linear gain (UA2725: 18.5dB)

2.5 dB noise figure (including RF switch) (UA2725: 1.8dB)

Ramp-controlled LNA gain

Low current consumption (UA2725: Typical 6.5mA)

Zigbee Wireless application-developing module